Log Meshlicious x AMD x cable management

RZEX

Caliper Novice
Original poster
Mar 30, 2019
29
48
Hi, I wanna share my build with you guys. I'm a Laker fan, so it's a purple and gold build😃😃😃

Hope you guys like it!


CASE:Meshlicious
CPU :5600X
MB :B550I AORUS PRO AX
RAM :Gskill 3200C14 16g*2
GPU: AMD Radeon™ RX 6700 XT

Watercool part

CPU :EK-Supremacy EVO - Full Nickel (Original CSQ)
RAD:Bitspower Leviathan SF 280
Fitting: Barrow and Bitspower
pump:Alphacool DC-LT 2600 Ultra low noise Ceramic
reservoir:Alphacool Eisstation 40 DC-LT - reservoir
Frosting surface acrylic tube

Please note that if you use Bitspower Leviathan SF 280, radiator can not be put at the front of the case.

Cable length
CPU:40cm
GPU:30cm
24pin:27cm

I moved all these parts from PC-Q37 to Meshlicious for better ventilation and 280mm radiator.


I put 2 2.5inch SSD at the back of PSU so that the SATA cable would be easier to manage.


3 #6-32 6.5+4 mm copper pillar was used to extend to GPU cable. With this method, I can hide all the cable behind GPU


Alphacool Eisstation 40 DC-LT and Alphacool DC-LT 2600 Ultra low noise Ceramic were used for a silent watercool build.




Alphacool DC-LT 2600 is really silent, and it's OK for a single rad and CPU waterblock.
 

RZEX

Caliper Novice
Original poster
Mar 30, 2019
29
48
Nice build. Why can't you put the radiator in the front?
Bitspower Leviathan SF 280 is a four port radiator, there will be conflict between the case and the stop fitting on the radiator.

Maybe you can get a corsair XR5 for similar performance.
 

griever

Average Stuffer
Apr 30, 2019
59
14
Beautiful. I love that cable routing.

Where di you find the 6-32 standoffs? I cant find any that are threaded 6-32 on both sides.
 

RZEX

Caliper Novice
Original poster
Mar 30, 2019
29
48
Beautiful. I love that cable routing.

Where di you find the 6-32 standoffs? I cant find any that are threaded 6-32 on both sides.
I got them from online shop in Taiwan.

I also found that there's same standoffs in taobao, maybe you can try aliexpress?

Another solution is that you can change standoff to 25mm or 26mm M3 standoff and use M3 screw for PCIE riser cable.
 

BaK

King of Cable Management
Bronze Supporter
May 17, 2016
938
939
Very nice and clean build, congrats!
Well maybe except for the colors theme.. Heat fan here! ;)
Great job on the hard tubes bending!
 

RZEX

Caliper Novice
Original poster
Mar 30, 2019
29
48
Very nice and clean build, congrats!
Well maybe except for the colors theme.. Heat fan here! ;)
Great job on the hard tubes bending!
Thank you!

It's ok Heat fan, we both out at 1st round 😭😭😭