Normal
Another take on the watercooling thingie: Just tested around with a cardboard mockup of the Arctic Liquid Freezer II A-RGB + fans, but with a depth of 65 mm - its a tight fit, but it should work!Side panel closes without any bulging, the mockup is still somewhat movable, does not press into the outcuts and outbounding molds of the mainboard / middle column .. so its worth a try!If its too tight of a fit, but only by 1 - 2 mm, then replacing the Arctic fans with 2x Noctua NF-A14 industrialPPC PWM fans (2000 or 3000 rpm) might be another option.Only if all of that fails, I am going to persue the Silent Loop 2 option + Arctic or Noctua fans.cu, w0lf.
Another take on the watercooling thingie: Just tested around with a cardboard mockup of the Arctic Liquid Freezer II A-RGB + fans, but with a depth of 65 mm - its a tight fit, but it should work!
Side panel closes without any bulging, the mockup is still somewhat movable, does not press into the outcuts and outbounding molds of the mainboard / middle column .. so its worth a try!
If its too tight of a fit, but only by 1 - 2 mm, then replacing the Arctic fans with 2x Noctua NF-A14 industrialPPC PWM fans (2000 or 3000 rpm) might be another option.
Only if all of that fails, I am going to persue the Silent Loop 2 option + Arctic or Noctua fans.
cu, w0lf.
