Normal
Ok I probably need to do a survey or something, or perhaps go back to the drawing board for the power panel design, come up with some alternatives.What I am trying to do is reduce the amount of 3D printing material as this is by far the most expensive part of the case to produce.The First Edition were sold at pretty much cost price, so unfortunately the next round of cases will have to be sold at a higher price. Reducing the amount of 3D printed material is a way to try and minimise that cost increase.But if the general concensus is that it has a negative impact on the overall aesthetic, then I need to re-think things!
Ok I probably need to do a survey or something, or perhaps go back to the drawing board for the power panel design, come up with some alternatives.
What I am trying to do is reduce the amount of 3D printing material as this is by far the most expensive part of the case to produce.
The First Edition were sold at pretty much cost price, so unfortunately the next round of cases will have to be sold at a higher price. Reducing the amount of 3D printed material is a way to try and minimise that cost increase.
But if the general concensus is that it has a negative impact on the overall aesthetic, then I need to re-think things!
