Normal
Excellent, I wondered if anyone would be brave enough to try this! Looking forward to seeing how it turns out.Don't forget as [USER=15]@iFreilicht[/USER] pointed out, you can't just drill holes to the diameter of the tubes as you need to fit the radiator or pump through the holes aswell! The only way to do it would be to have a cutout recessed along an edge.If I was to do this mod for myself it would have to be a custom panel, I would remove the 140mm fan mounting holes, reduce the fan cutout diameter and move the 120mm fan mounts over towards the front of the case slightly, the hose cutout could then be positioned vertically along the rear edge. The only problem would be potential overhang over the power panel, there should just be enough room.I could get the panel made for you, but not sure if its worth the cost of sending a single panel all the way to Australia?!Stay tuned, I'm hoping to use this combo for some photo's, probably a month or so away yet though.
Excellent, I wondered if anyone would be brave enough to try this! Looking forward to seeing how it turns out.
Don't forget as [USER=15]@iFreilicht[/USER] pointed out, you can't just drill holes to the diameter of the tubes as you need to fit the radiator or pump through the holes aswell! The only way to do it would be to have a cutout recessed along an edge.
If I was to do this mod for myself it would have to be a custom panel, I would remove the 140mm fan mounting holes, reduce the fan cutout diameter and move the 120mm fan mounts over towards the front of the case slightly, the hose cutout could then be positioned vertically along the rear edge. The only problem would be potential overhang over the power panel, there should just be enough room.
I could get the panel made for you, but not sure if its worth the cost of sending a single panel all the way to Australia?!
Stay tuned, I'm hoping to use this combo for some photo's, probably a month or so away yet though.
