Normal
Hi there and welcome to the Forum! Its good to hear the case made it all the way over to Australia!With regards to the FW141, yes that fan is 150mm wide an not compatible with the Full IO panel. I think the pictures you are referring to were of the LZ7 v0.1 prototype which was slightly deeper and so could fit these fans. When the design moved to v0.2 I increased the height of the case to cater for taller cards such as the Gigabyte GTX 1070 ITX, but in order to keep the volume under 7 litres I had to decrease the depth/length of the case.I have put a list of compatible fans that I am aware of on this page: http://www.lazer3d.com/compatibility-checker/case-cooling-fan-compatibility-checker/Or alternatively to tie you over until you can get hold of a compatible 140mm slim fan, you could always use a 120mm slim fan instead. The side panel also includes mounting positions for a 120mm fan which there are quite a few other models available. Hope that helps!
Hi there and welcome to the Forum! Its good to hear the case made it all the way over to Australia!
With regards to the FW141, yes that fan is 150mm wide an not compatible with the Full IO panel. I think the pictures you are referring to were of the LZ7 v0.1 prototype which was slightly deeper and so could fit these fans. When the design moved to v0.2 I increased the height of the case to cater for taller cards such as the Gigabyte GTX 1070 ITX, but in order to keep the volume under 7 litres I had to decrease the depth/length of the case.
I have put a list of compatible fans that I am aware of on this page: http://www.lazer3d.com/compatibility-checker/case-cooling-fan-compatibility-checker/
Or alternatively to tie you over until you can get hold of a compatible 140mm slim fan, you could always use a 120mm slim fan instead. The side panel also includes mounting positions for a 120mm fan which there are quite a few other models available. Hope that helps!
