Normal
I wasn't really planning on getting a bag for transportation. I'm planning on making a rig for LAN parties/when I visit my folks. The most arduous transportation I would be doing is just moving the PC from my place -> back seat of my car -> whoever's house I was visiting. In my case a handle would be very useful. I would just carry my PC in one hand and have my TKL keyboard + mouse + cables in my messenger bag.I've never installed a case handle before, so I was assuming that the four holes you drilled into the top panel were following some standardized case handle measurements. I was looking into a simple handle like this. Though given the picture of your daughter standing on the case and seeing the top panel bending a bit, maybe having a handle that attaches at the center of the panel is not the best idea. If you could design a handle that attaches closer to the corners of the case (like this prior design of yours), then maybe adding a handle would be worthwhile. I know your focusing on just releasing the case though, so I understand if there isn't enough demand from potential buyers to produce one.
I wasn't really planning on getting a bag for transportation. I'm planning on making a rig for LAN parties/when I visit my folks. The most arduous transportation I would be doing is just moving the PC from my place -> back seat of my car -> whoever's house I was visiting. In my case a handle would be very useful. I would just carry my PC in one hand and have my TKL keyboard + mouse + cables in my messenger bag.
I've never installed a case handle before, so I was assuming that the four holes you drilled into the top panel were following some standardized case handle measurements. I was looking into a simple handle like this. Though given the picture of your daughter standing on the case and seeing the top panel bending a bit, maybe having a handle that attaches at the center of the panel is not the best idea. If you could design a handle that attaches closer to the corners of the case (like this prior design of yours), then maybe adding a handle would be worthwhile. I know your focusing on just releasing the case though, so I understand if there isn't enough demand from potential buyers to produce one.
