Normal
I am not really familiar with the MeanWell power supplies, so I can only go off what I can see on the spec sheets searching for them online.I don't think there will be enough clearance in the HT5 for the UHP-200-12 to fit it to the left or right of the motherboard, the reason being is the corner blocks that hold the case together are 15x10x5mm and will likely interfere with trying to get the MeanWell to fit into that space.However, you may be able to fit it along the front section of the case and still be able to mount a low profile GPU or 2x 80mm fans. The only potential issue I can see is that there is 24mm clearance to the front of the motherboard and the UHP-200 is 26mm thick, so the module will overlap the front of the motherboard by 2mm and could potentially interfere with the 24 Pin ATX power connector on the motherboard (depending on your motherboard layout).Here is a view from the top with a mockup of the UHP-200:Here you can see the clearance in a bit more detail:I hope that helps a little bit, sorry I can't give any concrete answers as this is not something I have tested or have any experience with.
I am not really familiar with the MeanWell power supplies, so I can only go off what I can see on the spec sheets searching for them online.
I don't think there will be enough clearance in the HT5 for the UHP-200-12 to fit it to the left or right of the motherboard, the reason being is the corner blocks that hold the case together are 15x10x5mm and will likely interfere with trying to get the MeanWell to fit into that space.
However, you may be able to fit it along the front section of the case and still be able to mount a low profile GPU or 2x 80mm fans. The only potential issue I can see is that there is 24mm clearance to the front of the motherboard and the UHP-200 is 26mm thick, so the module will overlap the front of the motherboard by 2mm and could potentially interfere with the 24 Pin ATX power connector on the motherboard (depending on your motherboard layout).
Here is a view from the top with a mockup of the UHP-200:
Here you can see the clearance in a bit more detail:
I hope that helps a little bit, sorry I can't give any concrete answers as this is not something I have tested or have any experience with.
