Patreon & K1 Max Launch
[MEDIA=googledrive]1uLOIlOsGIMq8bzyLdOWaGwpiweYqkQKy[/MEDIA]
Creating these modular and versatile ITX PC cases takes a lot of time and effort.
But hear me out!
It all started with the Kibo K1 240 as an novelty project, bringing modularity and design together to create a 3D-printable Competitor to the Boutique ITX Case Scene(e.g. T1, Wintercase, louqe S1, etc.), that were at the time (2021) not broadly accessible.
As time moved on, newly released GPU sizes grew, resulting in a new demand for cases for those larger GPUs. Thus a new dream was born, to create a fully 3D-printable Mainstream ATX Tower. And the first step for me was to adapt the old K1 240 to the current demands:
Fitting an oversized GPU in an ITX Case, while preserving the same space efficiency is hard!
If you find value in the K1 concept and want to support me on these projects you will find me at my Patreon page, offering membership rewards such as the Files of the K1 Max.
If you want to make a purchase instead of joining a membership, I also have set up my Ko-Fi Shop.
Thank you for the support!
[MEDIA=googledrive]12ZvwvEMfplEI6djtaTjdyGQPqKuyVXwv[/MEDIA]
PCIE Riser length
The minimum length of the dual reverse riser will be 190mm, as my ssupd 185mm one is a bit short to be mounted into place.
[MEDIA=googledrive]1o6yntaVYv7S5lQfiMIGukVKwdnUQpmpl[/MEDIA]
GPU MTB Gap
I hope that an 8mm gap between GPU Backplate and Motherboard will be enough to avoid shorts or any unforeseen electrical issues. If so pls „mach mich schlauer!“ fill me in.
[MEDIA=googledrive]1DQFqjtkscLweMMcc2EvjNSdTa3XkgeAZ[/MEDIA]
