Normal
Hey [USER=26600]@Kiborato[/USER] , reading my post again, I may have been overly negative about PLA. Looking at the actual parts you're printing, I think the most critical are the ones that make the spine inside the case. They will endure the highest temperature and have to carry the most weight, while also being the smallest parts. These ones probable should be printed in ASA or at least PETG.The shell parts and top+bottom will be a lot cooler and are probably fine in PLA.
Hey [USER=26600]@Kiborato[/USER] , reading my post again, I may have been overly negative about PLA. Looking at the actual parts you're printing, I think the most critical are the ones that make the spine inside the case. They will endure the highest temperature and have to carry the most weight, while also being the smallest parts. These ones probable should be printed in ASA or at least PETG.
The shell parts and top+bottom will be a lot cooler and are probably fine in PLA.
