How to get a single Slot 1080 ti Mini

[Gehringerj]

Hello,

recently I snipped the DVi port of on my Zotac 1080 ti Mini, but sadly damaged the card.

So this thread will be a how to repair your GPU thread – hopefully!

In the prozess of cutting the DVI port i hit one of the caps and chipped one of the resistors on the backside of the card.

After some reseach i found a matching cap and ordered it.
Some days later it was solder-time. What a fiddly work, but yes I get it! Succsess!!

[Pics of the new Cap and how to solder that thing following soon ]

So on to the next challenge - the resistor

Sadly I never found that lost resistor from the GPU again, so does anyone here have a 1080 ti Mini and is willing to check the electrical resistance of that resistor (as shown in the pic)?

That's where the project stops at the moment.


best regards

Jay

 

[Fede]

Wow, that's really bad luck ☹
These resistors are really small and very complicated to soldering.

Did you search in google? Maybe some review with good quality phots you can see th resistor.

 

[oOflyeyesOo]

Are there similar sized ones near the dvi port you cut off? Probably some that may be fine to remove that controlled that port.

I used to fix phones and harvested many from random boards. This is a tough repair. I used a hako hot air, a heat gun may assist if it has a small tip. Using a soldering iron with these is really tough, always wants to stick to the iron.

Steady hands..good luck!