Normal
Thank you for the welcome!I work a lot with SolidWorks and Creo (Pro E), I will be sure to check out all the resources and even try to post some models that I've done if I can.At the moment I am working in the safety industry developing breathing protection equipment, I am hoping to apply some of what I've learned about airflow from this industry into methods of efficiently flushing heat from PC cases.I will try to start a thread on the cases I'm working on, both of which are based on heat bent Acrylic, the reason for this material was mainly due to the relatively low cost of small batch runs compared to metal based components, but after reading on this forum about companies such as Protocase, I may look at changing the design to metal enclosures.
Thank you for the welcome!
I work a lot with SolidWorks and Creo (Pro E), I will be sure to check out all the resources and even try to post some models that I've done if I can.
At the moment I am working in the safety industry developing breathing protection equipment, I am hoping to apply some of what I've learned about airflow from this industry into methods of efficiently flushing heat from PC cases.
I will try to start a thread on the cases I'm working on, both of which are based on heat bent Acrylic, the reason for this material was mainly due to the relatively low cost of small batch runs compared to metal based components, but after reading on this forum about companies such as Protocase, I may look at changing the design to metal enclosures.
