Normal
I am that OP. Just registered to add more information to this.I did not remove my card's backplate. I did not cut my case nor card.I have no cables behind the card's backplate, The card should slide in, and side panel should close.However one of the fans would be rubbing against the side panel. To solve that some rubber pads are added near the fans to make extra room.The side panel will not close nicely, so I used transparent tapes to reduce the gap between side panel and the case.No permanent modification should be done for the setup to work.
I am that OP. Just registered to add more information to this.
I did not remove my card's backplate. I did not cut my case nor card.
I have no cables behind the card's backplate, The card should slide in, and side panel should close.
However one of the fans would be rubbing against the side panel. To solve that some rubber pads are added near the fans to make extra room.
The side panel will not close nicely, so I used transparent tapes to reduce the gap between side panel and the case.
No permanent modification should be done for the setup to work.
