Reply to thread

Message

Looks like the internal volume of the enclosure is 20.5cm once you yank the fan (assuming that is a 25mm deep fan). The 160 is 40mm high which means you're looking at 16.5cm for your GPU (minus the bracket). Fairly certain the only card that would fit in that would be an R9 Nano? Also the HDPlex is 150mm long, and 131 if you were to clip off the fixation brackets on either end. Again you're probably going to run into issues because while the enclosure is 131mm, there are wires on either side that are going to add to the functional length of the unit (ie. Like how PEG connectors make GPUs effectively taller in many cases. Also from my recent testing, the HDPlex runs quite hot, even at relatively low loads (80-90W from the wall). See my Orangulan build for more details on how I mounted etc.

[QUOTE="Kmpkt, post: 17868, member: 206"] Looks like the internal volume of the enclosure is 20.5cm once you yank the fan (assuming that is a 25mm deep fan). The 160 is 40mm high which means you're looking at 16.5cm for your GPU (minus the bracket). Fairly certain the only card that would fit in that would be an R9 Nano? Also the HDPlex is 150mm long, and 131 if you were to clip off the fixation brackets on either end. Again you're probably going to run into issues because while the enclosure is 131mm, there are wires on either side that are going to add to the functional length of the unit (ie. Like how PEG connectors make GPUs effectively taller in many cases. Also from my recent testing, the HDPlex runs quite hot, even at relatively low loads (80-90W from the wall). See my Orangulan build for more details on how I mounted etc. [/QUOTE]

Verification