Normal
I had this issue yesterday while building my second Dan A4 for the wife. It’s not quite level is it? Seems to make a close enough connection for me though.On an interesting side note; the build for my other half I wanted to make as quiet as possible and she only does light gaming. I looked at the KalmX 3050 but the specs are not worth it, even though it’s good for what it is, and the fin stacks are in the wrong orientation.I settled on the Strix 4060 which is a three slot 310mm card (yes I know). I removed the shroud and screwed the back plate on with some nylon M2 bolt/nuts with washers (shroud holds back plate on). To my utter delight it slid right in and fits perfectly, with maybe a mm or two to spare. I like to call it the Kalmx 4060 Stress tested and no worries, with the bottom fans pushing air up at minimum RPM it barely reached 70.
I had this issue yesterday while building my second Dan A4 for the wife. It’s not quite level is it? Seems to make a close enough connection for me though.
On an interesting side note; the build for my other half I wanted to make as quiet as possible and she only does light gaming. I looked at the KalmX 3050 but the specs are not worth it, even though it’s good for what it is, and the fin stacks are in the wrong orientation.
I settled on the Strix 4060 which is a three slot 310mm card (yes I know). I removed the shroud and screwed the back plate on with some nylon M2 bolt/nuts with washers (shroud holds back plate on). To my utter delight it slid right in and fits perfectly, with maybe a mm or two to spare. I like to call it the Kalmx 4060
Stress tested and no worries, with the bottom fans pushing air up at minimum RPM it barely reached 70.
