Normal
I hope not because mine is apparently 2mm longer than yours. Granted the fin design is different in my situation and I think the aero is slightly slimmer. But I'm not sure. Hopefully it works out with shroud attached. Doesn't make any sense as to why yours doesn't fit though. Maybe your PC extender isn't scooted far enough to the back of the case which is why it may not work with your PC bracket?[USER=1175]@sergiiua[/USER] may have to address this. I haven't seen anyone with above a 1050 or something similar in size in this chassis yet so if it doesn't work case may have to be extended a tad. I could always mod part of that bracket to help with fitment if it becomes the case grind that metal down just enough for it to fit or something. Idk. I'm bound and determined for my card to fit.Can you post a picture from above and front?Yeah the aero has an indention on the heatsink around where the rivet would be so I should be fine in that regard. Plus my shroud doesn't extend off the edge of the PCB at all. I measured it just a few minutes ago and it measures a hair shorter than what MSI claims luckily. So mine should be a perfect fit. I'm hoping. It barely extends past the motherboard so it should be perfect I'm thinking.
I hope not because mine is apparently 2mm longer than yours. Granted the fin design is different in my situation and I think the aero is slightly slimmer. But I'm not sure. Hopefully it works out with shroud attached. Doesn't make any sense as to why yours doesn't fit though. Maybe your PC extender isn't scooted far enough to the back of the case which is why it may not work with your PC bracket?
[USER=1175]@sergiiua[/USER] may have to address this. I haven't seen anyone with above a 1050 or something similar in size in this chassis yet so if it doesn't work case may have to be extended a tad. I could always mod part of that bracket to help with fitment if it becomes the case grind that metal down just enough for it to fit or something. Idk. I'm bound and determined for my card to fit.
Can you post a picture from above and front?
Yeah the aero has an indention on the heatsink around where the rivet would be so I should be fine in that regard. Plus my shroud doesn't extend off the edge of the PCB at all. I measured it just a few minutes ago and it measures a hair shorter than what MSI claims luckily. So mine should be a perfect fit. I'm hoping. It barely extends past the motherboard so it should be perfect I'm thinking.
