Dimensions are to the inside of the frame
Dimensions are to the inside of the middle frame section, there is another 1mm on top/bottom/left side if the rad is offset from the front by a fan.
Also, all dimensions are rounded down.
Handle mounts to a bracket (which will come with the handle) so the top panel isn't taking any weight.
The SFX inlet clears the FrozenQ M1 res unless there was another res you had in mind.
Well, it's 5mm split between each side so it'd be another 2.5mm closer to the headers.
It's hard to tell since it's not a simple box but it should fit to the front if the pump/res is down so it clears the motherboard. That would not leave room for the 3.5" bracket on the side. The drives would fit on the bottom but not with a 120mm down there too.
240mm on the bottom with 120mm on the front should work.
There's only a 1mm gap between the tray and the back panel.
Current spacing is 144mm (which aligns with the panel vent pattern) so it's not compatible with that handle.
