Reply to thread

Message

I ended up not using your backplate. The point of a backplate is to provide rigidity to prevent the motherboard from bending. Your backplate being printed with PETG completely defeats its purpose. I printed a set of washers instead. 1.5mm high PETG washers to put between the brackets and the mounting screws and 1.7mm PLA washers to use between the motherboard and the nuts. I had designed a whole backplate to be printed in PLA but given that Cryorig themselves provide washers to use on ITX boards where the backplate doesn't fit, I decided against it.

[QUOTE="Jovogdiar, post: 180388, member: 7000"] I ended up not using your backplate. The point of a backplate is to provide rigidity to prevent the motherboard from bending. Your backplate being printed with PETG completely defeats its purpose. I printed a set of washers instead. 1.5mm high PETG washers to put between the brackets and the mounting screws and 1.7mm PLA washers to use between the motherboard and the nuts. I had designed a whole backplate to be printed in PLA but given that Cryorig themselves provide washers to use on ITX boards where the backplate doesn't fit, I decided against it. [/QUOTE]

Verification