[USER=641]@NateDawg72[/USER] : still my awfull test bench !
[MEDIA=imgur]M4rGa5N[/MEDIA]
[MEDIA=imgur]TpSVFEZ[/MEDIA]
The direct plug unit is directly wired to the EPP-400-12.
The One2 board is also powered by the EPP-400-12, in "always ON" mode.
Maybe I should try to power the direct plug unit through the "always ON" 4-Pin connector of the One2 to avoid cold boot issues ?
Indeed, on some occasions, the LED power of the motherboard will light up then shut down immediately.
The 180mm fan will continue to run but the pump won't start.
No POST.
I have to manually shut down the AC Line then wait and press again the power button to be able to boot.
What kind of inline connectors could I use to extend both 12AWG silicon wires of the direct plug unit ?
[USER=9554]@arataisozaki[/USER] [USER=294]@Thehack[/USER] : this is the kind of solutions you were mentioning end of October right ?
