Normal
Hello [USER=294]@Thehack[/USER],a small question to the master of meanwell and 12v, if I may ^^It's concerning the connection between a meanwell 200w and a picopsu-160-xt.From the pico, on the molex connector, I have 2 awg16 (+ 2 awg22 shorting the 2 remaining contacts).Would it be better to :- do the same thing on the other side of the molex (but with awg18+awg22), and so only use two contacts on the jst connector on the other side of the cable connecting on the meanwell (which has a plug with 6 contacts)- or connect 4 awg18 cables on the other side of the molex and thus also use 4 contacts on the meanwell side ?If the second solution is better, is it not dangerous for the small awg22 cables on the molex (pico side) ?Edit with picture :
Hello [USER=294]@Thehack[/USER],
a small question to the master of meanwell and 12v, if I may ^^
It's concerning the connection between a meanwell 200w and a picopsu-160-xt.
From the pico, on the molex connector, I have 2 awg16 (+ 2 awg22 shorting the 2 remaining contacts).
Would it be better to :
- do the same thing on the other side of the molex (but with awg18+awg22), and so only use two contacts on the jst connector on the other side of the cable connecting on the meanwell (which has a plug with 6 contacts)
- or connect 4 awg18 cables on the other side of the molex and thus also use 4 contacts on the meanwell side ?
If the second solution is better, is it not dangerous for the small awg22 cables on the molex (pico side) ?
Edit with picture :
