Normal
I'm going to put more emphasis on being able to position this case both vertically and horizontally. Here's a render of a case build in the vertical position.In a horizontal position the PSU might have to be mounted on standoffs to route the power cable below it.Plus, the width has been increased on the CPU side to allow CPU coolers up to 47mm tall Edit: Also, I have settled on two side panel patterns to use for the case.Both patterns have diagonal angled cutouts to let warm air vent from the edges, and are mirrored on both sides. I have calculated the pattern on the left to be cheaper than the one on the right, because even though they are similar in total area ventilation, the pattern on the right requires more individual shapes to cut out, using more cutting time.
I'm going to put more emphasis on being able to position this case both vertically and horizontally. Here's a render of a case build in the vertical position.
In a horizontal position the PSU might have to be mounted on standoffs to route the power cable below it.
Plus, the width has been increased on the CPU side to allow CPU coolers up to 47mm tall
Edit: Also, I have settled on two side panel patterns to use for the case.
Both patterns have diagonal angled cutouts to let warm air vent from the edges, and are mirrored on both sides. I have calculated the pattern on the left to be cheaper than the one on the right, because even though they are similar in total area ventilation, the pattern on the right requires more individual shapes to cut out, using more cutting time.
