Recent content by yuzhongliang22

This is v2.0 lol, but v1.1 can fit as well. The back panel and riser cable should be unmounted first, plug the card into the riser, mount the riser(and the card) finally install the back panel. took me 3 hours to figure it out lol, it is really tight. Image

Hello, will 4090 FE fit in T1 1.0? Do I have to replace my old case? I know 4090 FE is 1mm thicker than T1's recommend size (60 vs 61), but has anyone tried that?

This is the correct position to install ur riser. If the standoffs screw are too long, try cutting them off a bit or just get rid of that standoff. btw it is recommended to have the mobo installed and plug the riser into the mobo before you screw the gpu-side into the bracket.

well i just pushed my gpu down and loose the braket screw to move it a little bit and it was fixed, very tight but work XD thanks

Just get my build runnning but it seems the lt240 aio does not fit in 3 slot mode? is there any image about how to route the pipe or i should buy a h100i instead? and my riser cable was blocked by gigabyte b550i's backplate and it is not long enough to reach the correct position, should i remove...

Wondering which mobo should i buy to match my 5900x... Since OT said there's something wrong about asus b550i and x570i, i'm still comparing gigabyte b550i and msi b550i mobo having any ideas😅 btw, my case arrived 2 weeks ago and it looks so good i'm building a 5900x+3080 system, if i can get...