Recent content by YdderMkIV

Yep. Kickstarter backer, can't figure out how to get the tempered glass panels or the pci 4.0 riser. Can't login to the website. Used the Contact form on the site - no response. Posted here a couple times nothing. Haven't been here for a while - good to know everything is just how I left it!

i've been out of the loop for a while...how do I go about getting replacement parts for my case (OG kickstarter batch, non-tempered glass panels, Booster Cell that cannot have a fan cable run through it, PCI 4.0 riser etc). I tried ordering an extra o2 panel as well, but the website wouldn't let...

where/when can we expect a tracking number? I haven't seen anything (Dark, USA) yet

I am assuming it is the "Dark" that have started going out before the others? Out of curiousity what is the status of the other two colorways?

This is nowhere near as bad as the Mjolnir. The distribution channel stuff is definitely poor on their part, but at the end of the day, the cases have been manufactured loaded and shipped. They're now just stuck on a boat, which is tough, but not much anyone can do about it. On the other hand...

does anyone know if these are in fact going to be shipping from Newegg on the 20th?

whats the status of the QC units? According to the last timeline you should have them in hand, any updates?

It would be ridiculous to have to pay extra for air shipping at this point. Remember when the cases were definitely going to be done before CNY, and then 95% sure going to be completely finished and shipped in March? At the end of the day the case will ship a full year late, and whatever the...

I apologize for the snark earlier, but again, you are being wayyyyy too optimisitc in how smoothly and quickly things are proceeding. It seems like you haven't looked too deeply into the certification process so far. It's good that you're looking for help. But even I remember @Alloy Craft...

Don't get your hopes up they'll just continue to miss literally every deadline they've set for themselves and say "(Odin/Thor/[Insert Norse God])'s (beard/hammer/accessory)!! Who could have seen this coming!?!?" and then rinse and repeat. Until this case gets into my hands I'll...

really great design looking forward to the kickstarter

Mould creation and actual fabricaton times stack right? So we are looking at 1 month for mould creation + 2 months production + 1 month (pessimistically) for electronics/fasteners = 4 months. Thats the 2nd week of January unless I have the timelines wrong? (which I hope I do)

@AlexTzone Reading the latest kickstarter updates, it sounds like you mentioned an "ETA of September" Is this ETA when you expect the cases to be shipped out or when you expect final manufacturing to start?

The early prototype reviews from OptimumTech and RandomFrankP both mention the the friction between the core and the shell, and that the "tape" along the contact points in the corners would start coming off. I know that issue was supposed to be fixed, that being said, have you looked at the way...