Recent content by Wenemun

Just built in my new case, still some work to go, but it's up and running. Good work Bernardo and z-case team. Really loving it. Initial thoughts: Great finish and build quality. The cables tuck VERY snuggly under the psu shroud. PSU is great. Even with this system (8086k+2070 more specs...

We're in the last week of August now. Could you provide an update for when these might start shipping?

Those sounds like super easy mods. Good ideas! Something like this would work, but would mean drilling into the case. It would be great to have a servo or something to move it as well, based on the temperature. Or instead of hinging it, it could just raise and lower the glass. (I plan to have...

Just pulled the trigger and ordered one. I'm so excited!

Thanks but the point is (was) to make it as cheap as possible. Which part in particular would you suggest 3D printing? There are more updates to come. A lot has changed since September.

Pretty accurate from hi-res photos and plans on website. Fan-less thermal solution, 0 dBA acoustics ￭ SFX-L form factor for use in small form factor computers ￭ High efficiency with 80 PLUS Platinum level of efficiency ￭ 100% modular short cables with flexible flat arrays ￭ 24/7 continuous...

Wenemun submitted a new resource: Silverstone NJ450-S NightJar SFX-L PSU - 450w fanless PSU Read more about this resource...

Main thing is the voltage ripple, and turning the psu on and off... Have a look at the 12v thread https://smallformfactor.net/forum/threads/a-guide-to-12v-psu.1270/

Spend the money on a better board rather than custom heatsink. You're just rolling dren in glitter. Also, do you really want your vrm to melt and the caps to pop, because thats what will happen, even with extra cooling, cruddy vrms are still cruddy vrms, they have a max amperage they can take...

You don't really need VRM cooling if you have a down force air cooler going over them... Only reason they do it on water blocks is because they have no airflow...

Great idea! Looks like a speaker. I like the look of the one on the right too. I'd want to put the PSU under the mobo to keep all the cables together though. Maybe put some drives in the top space. Also can you fit pushpull config? I also worry about the VRMs. They run pretty hot on the 2080ti...

It works out of the box.

Mk2 – September 2018 I had the thought that if i was still going to use a HDPlex, and it needs to be 80mm high then i could put 120mm fans over the heatsinks. Also, i do like my RGB... I had the idea to make it so it could be a variable height, so I could decide whether to put in the 120mm fans...

The Reem. The intention of this build is to replace the dvd player and play games. This was originally to put in a z97 asrock itx/ac board with 4690k and gtx 950 (210mm long) I have laying around after upgrading to z370. It also needs to fit a dvd drive, and have a front usb port. It needs to...

m.2 is the connector type. nvme or SATA is the controller interface/storage protocol. m.2 can be either. nvme is like 2-3 times faster.