sure, i am working on that, i plan to fit a RTX3090 in there. But i am not shure if i should make 2 cases and you can select or just make a bigger one.
as a little update, i have some issues with my testing rig, i have some bluescreens after my windows update, i reinstalled the hole system but...
i do not recognize any noise from the PSU right now, i will measure the temps as good as i can with an external temperature sensor to see how good or bad it is, what i can say is the air which comes out at the top isnt that hot under full load, so i think the air which is more or less pressed...
What i can tell right now from testing, i notice no big difference (1-3°C) in CPU and GPU temps with and without the side panels. so ventilation is fine, but i am working on a big update on the case for a all aluminum CNC produced case and there i will add an option for glass or vented metal...
so i am almost finished with the prototype and post some a update on the assembling process
the new SSD mount is behind the FLUX logo, 2x 2,5" SSDs can be mounted there
perfect fit for the NH-D15 :)
space optimizied :D
Hello, sry long time no update, i was so busy the last month, my 2nd daughter was born, much to do around the house, but now i have a update to share. i made the comparison between my old Inwin101 and my new selfmade Flux A1.
Here are the results:
you can see in green the Flux A1 case and CPU...
yeah FLUX will be the company name and the type/model for the this case is A01 (A=air), because i also plan to make a W01 (W=water) case for watercooling in the future, but the Chamber aspect is also very nice, i will think about it :) thanks
sry for no reply but i have another project house/garden/fence :D
i am waiting for some parts which i have ordered to do the rework. On the weekend i will work again on thermal testing.
for sure i will add another 4-5mm to fit the morpheus cooler, but not the MK26 from prolimatech, i have it at...
i am working on something like that, i rework the design now to make it even smaller and easier to assemble, it took me some time to assemble it and thats not for everyone.
i can check it with a 3D model wenn i am done with the redesign.
@TeutonJon78 yes but i can add an additional layer of acrylic, than the IO shield should fit :)
@harry2009 i checked it, and the distance from the PCB GPU to the fans is 44mm, so the Morpheus is 25mm in height, i dont know exactly the height of the GPU chip, but if i add 5mm in height to the...
no, its only 3mm, i will modify the plate where the mainboard is mounted and slide it to the front, so i have 4-5mm more space, for later i will adjust the mainboard-mounting-holes in the plate
i will fix it on monday, so i have access to a workshop where i can do this
i just installed all the hardware and run some first tests, i have to rework some parts and adjust a little bit.
the fan in back should not be outside of the case, but the space between the backplate and the cpu-cooler is 22mm ?
so my 3D model from the mainboard was not that accurate...
Thank you very much.
yes for now i will test how the temps will be if the fan from the PSU is in front of the CPU cooler, i can flip the PSU by 180° so the fan is in the front position.
also it is possible to flip it only 90° an make a small cutout in the front for fresh air for the PSU.