Recent content by tenrose

this case is exactly what i'm looking for. side panel cpu intake would do well i think, im looking to make a portable caming system with DC-DC power and 1050Ti. can't wait!

that's a bit of a shame to be honest.

i would like to see if we could mount two 120mm aio for cpu and gpu in the top instead of a shared 240mm rad.

Have you done this yourself? The whole kit there looks quite a bit over my planned budget of £150.

Hey guys, I'm looking at getting the Lian Li PC-Q38WX for my rig. I'd like to AIO cool both my cpu and gpu, but I'm not sure if this case can fit two 120mm AIO in the top. Has anybody tried this before? Thanks ten

the modular side panels i was talking above in my post above could allow for this extra width. i've seen a build with 3d printed spacers for the side panels to allow extra cpu cooler height, perhaps something like this could be done to allow for the extra width required

going off this it would be nice if the panels were modular, in that you could purchase sides and a top which allowed for room to mount a 240mm rad + fans in the top of the case. similar to the tophats of that other expensive sfx case which looks similar.

this case looks wonderful can i just buy the prototype?

the usb cable for the front IO on the v3 is molded in a way where it doesn't interfere with a 92mm AIO radiator mounted at the front bottom of the case afaik dan hasn't got any plans to make the usb cable available for purchase

Got Windows installed on my new build last night (finally). No GPU yet but I performed a Prime95 stress on the CPU: i7 7700K 4.2GHz Cryorig C7 w/ 120mm Noctua 15mm 97C (yikes) Underclocked the CPU to a measly 4.0GHz and it now sits at 80C under maximum load. A delid should get me a bit more...

it doesn't look like many details for card length have been released yet, but the PNY 2080 triple fan is 29.5cm or so. this won't fit as the internal dimensions are smaller, but we can use that as a baseline to get a rough idea of what might fit. for example i firmly believe the reference cards...

yeah after seeing the stream i checked overclockers and there's a few which will fit easily. the difference in power compared to the 10 series is incredible.

so far the leaked images of RTX2080 and RTX2080Ti show little hope of fitting as most are either wider than two slot or longer than 30cm. can't wait to see what nvidia announce this evening https://videocardz.com/nvidia

i read somewhere dan is wotrking on them, i dont think there's a timeline on their rerelease sadly

i scratched one of my side panels of my new v3 pretty much straight out of the box and am gutted. would be nice to be able to buy a replacement.