Recent content by ShorteCut

Good information! The more the better. I was working on some changes and actually removed those red bends. There will be some welding done instead. My thanks!

Hm, ok, good to know. Going to make some calls to see what tolerances they can take/hold once I get a bit further. As far as I know, I'm fairly limited to what company I can turn towards. Not to keen on driving too too far.

Thank you! I'll gladly take one copy for reference! For once I'm happy that standards are so hard to change. I used both SSF's model and protocases's model and followed some of protocases's "specifications". Seems to fit both models well enough. I'm sure during manufacturing that they wont be...

Thanks for the feedback, much appreciated! Yea, there is supposed to be one exhaust-fan above the motherboard I/O as you mentioned for a total of 5 fans (4 in, 1 out.) The idea was that I will be able to have them run at a low RPM, i.e low noise. If my computer can handle it, I was planning on...

Thank you! :) The community/site seems really neat! It was such a funny coincidence that I found this page! I saw the HardwareCanucks video (link) covering this case, when it came out, and it just so happened that I was trying to make my own "slim" cube case (link) and then found this site a...

Looks amazing! Saw this on HardwareCanucks on YouTube!

Table of Contents ====================== 1. Introduction 2. Concept 3. Current state (Help!) 4. General 5. UPDATES - (Latest 2016-03-27) ====================== 1. Introduction I've always wanted a small air-cooled cube case for several reasons, but I've never found one in the mATX form-factor...