Recent content by PorKOON

Unscrew the GPU riser, install the extra ones on top of the standoffs already installed, and screw on the GPU riser.

If you don't need the extra mobo standoffs that come with the case, use two of them (on top of the ones already installed) to extend the GPU riser out. The extra 5mm of clearance makes a huge difference on the 3080 FE, but not sure about a 3060 AIB.

Nope, no issues at all. I like the positioning of the FE more now in my case. Aside from better temps, the ports aren't as close to the edge, the card seemed easier to screw down, and the back exhaust is exposed slightly more. My 5600x runs pretty hot too. I set it to Eco mode last night and...

Interesting, I can't seem to edit my original post. Anyways, I meant to say I had to originally pull the GPU out a bit more to screw in the back. The standoffs created a better alignment.

When I first put in the GPU, I actually had to push it in more to screw in the rear of the card. The additional standoffs actually made it allign better. My GPU fans peak at around ~1,800 RPM in load, which is coincidentally the same RPM as the PSU.

Just creating an account to post this, since I also posted my new build on /r/sffpc. In short, the 3080 FE works great as long as you install additional spacers on the GPU riser. Below is just a copy and paste of my /r/sffpc post. Hope it helps! Specs: • Case: Dan A4 v4.1 • CPU: Ryzen 5600x...