Recent content by Pancake

Awesome build. Finally someone mounts the d12l as it is supposed to be. What are those ram sticks under the heatsink? Curious about the maximum ram height in this configuration. And it is possible to place the power connector at the lower hole?

Awesome build. Finally someone mounts the d12l as it is supposed to be. What are those ram sticks under the heatsink? Curious about the maximum ram height in this configuration. And it is possible to place the power connector at the lower hole?

Looking forward to the new C4sfx witht matx support and that new bottom design.

The two fans on the right are 2mm higher than the one on the left. They are a bit too close to the side panel so you cannot expect a quiet operation.

3D printed an customised psu bracket. This 9015 really helps with the airflow.

Update: 3d printed a supporter for a noctua 40mm. It will slide into the a9x14's frame. Slightly tilted for a potentially better airflow. Front ssd temp is now 9°C lower at 54°C during fpu.

I happily cut the clip on the 8pin and then found I had cut the psu side😭

Thx. A new discovery: I found the bottom fan under the mobo gets really noisy when used as exhaust. The reason is the edge of the mobo is too close to the fan (it’s actually touching the fan frame) , blocking the air swirl going into the fan. This holds true for any 9015 and Noctuas. A 3-5mm...

I noticed my ssds are having really bad temps and have been trying different fan configurations. When idle, ssds are around 50-52, seems ok, but when runing fpu, and when cpu stablises at 80 degs, both ssds are heated up to 60-62. If I run some ssd benchmark at this time, they hit 70 in no time...

Thanks to all the replies. And here comes the finished build :) https://smallformfactor.net/forum/threads/my-first-sff-build-dan-a4-sfx-v4-1-silver.16366/

My first SFF build, trying to strike a balance among performance, appearance, compactness and noise etc Components: B460 + i5-10400 + 16G + 1660super (cpu undervolted by 0.125V for) SN750 500G + SN550 1T L9i chromax.black + 2 * Thermalright 9015 PSU SF450 Platinum Cable management was a...

Here that giant power supply cable conflicts with the 9015 under the mobo. Is it meant to be like that? I could force the power plug in but the cable will be squeezed.

Hello. How's this request going? Still there? Since the width is increased by 5mm, how about also increasing the height by 5mm to accommodate a 9014 on top of the mobo? (which I presume would drastically improve the airflow