Recent content by Overtek

I will avert my eyes...till at least enhance modular 450W Platinum flex ATX PSU's are sorted. Looking good though, silicone looms nice for moulding and already have confirmation they will also fit velka 3 V3

Now there's a mad idea. There is already a 1:17 scale container trailer in existence, all be it for a full 40' such a bad influence, this has surely gone far enough already.

AND THEN!!! Intrigue builds again

Small number of white paint finished units will also be available

AMD RX6400 Discounted from £112.60 to £99.00 (approx 128.60USD) when ordered with Densium APU. Free worldwide shipping included. Note, Only UK orders only will be subject to the incVAT prices (+20% on the above prices when applicable)

Yes with ease on the silicone cables

Silicone loom loveliness. It's just as hoped finally.

The things you lot get me to sort out. Now you BOTH have to order one immediately!! 😁 Test sample size: 2pcs, production unts Test Equipment : 1 AC POWER SOURCE Chroma 6530 2 Load Chroma 6314A 3 Load (make/model not disclosed) 4 Power Meter Yokogawa WT210 5 6 1/2 digit DMM HP34401A 10% load...

I'm guessing you've seen all the 20V 240W ones 42x70x115mm or 127x63x33mm sort of sized

The 4 available from April, free shipping worldwide. https://www.overtek.co.uk/collections/densium-sff-cases/products/densium-4-v2-sff-case-mini-itx-with-hardwood-front-panel

I'd seen some strange things going on with HDPLex 250W GAN mountings.. I looked at this previously and worked out that there appeared to be a dual positional 3 hold alignment. With a little time free approaching, decided to pull in a HDPlex to physically see myself what was going on with all...

Finally got round to this. This is the internals originally from an FSP500-50FSPT a short live product, as it wasn't particularly reliable and had to many failures. Anyway as you can see most of the internals are the same similar except the daughter board that does have the 5V power posts. This...

Right, it's taken a long time but we have a vendor in place who's confirmed they will do silicone loom. We'll see samples at end of Feb / start of March as they've knocked off pretty much for Feb for a long CNY break. First sight of our black sample unit. Loom pictured is not silicone, or...

Yep add a dcdc or just tie it into 5vsb. Will be easy to tell if no dcdc added and tied to 5Vsb as every 5V DC pin will be live with mains present without ps on taken active low Or because of the way FSP and most work it maybe present on the PCB with terminals, as it will be more time effective...

Custom looms always possible, initial orders will be the standard quoted loom and ship direct to minimise delay.