Recent content by Oogar

You can check out my post from a couple pages ago if you are willing to get a custom cable...it mostly fits :). https://smallformfactor.net/forum/threads/dan-c4-sfx.12329/post-278894

Yeah, both photos included that double-sided tape. Definitely minute from the top down, especially when it's the panel furthest away from me when sitting on my desk. Without the double-sided tape though, a front-view of the case will have the side panel extended further out sideways past the...

Here are some shots of what I am talking about. Right panel has slight space on right-hand side. In red is where I roughly have the double-side tape.

Thanks! I tried that right-angle adapter with the 4090 and it was definitely a no-go. Way too chunky. I used the custom configurator on Cablemod's website and opted for the SFF-targeted cables (unsleeved). There they had an option to do a 4x8pin to 16pin right angle variant b adapter. The custom...

Finished build. It includes a few interesting things that might be helpful to people. E.g. SFX-L power supply with custom Cablemod cables Right-angle 16pin cable for 4090 from Cablemod. Puts a tiny bit of pressure on the side panel that I fixed with a small amount of double-sided tape to make...

Had the same conundrum. SF1000L stock cables were fine for everything except the 4090, the bend was going to be way too janky. Decided to go with the Loki but still feeling a little bit uncomfortable having a bend so close to the 12VHPWR connector. Cablemod sells a right angle 16pin to 16pin...

Makes sense! I also went with the commonly recommended G.Skill Trident Z Neo 6000mhz kit for Ryzen at a whopping 44mm tall so I am SOL there :D

Test I tried a couple combinations and attempts at getting the NH-D12L with 2 120mm fans but there doesn't seem to be enough room. Restricted by MB cable(s) position, I/O, and RAM. I ended up with the below configuration. That 92mm fan at the back is essentially sitting on the motherboard...

Test