Recent content by gergl

Just some black wire, I would've loved to zip tie it like yours but I just couldn't get it to work with the structure of the heat sink

Nice! I bought a EVGA 1660 ti SC Ultra for a build this winter (right before prices got crazy) just to mess around with it (overclocking, patching the NVENC limit). I ended up adding thermal tape where the heatsink wasn't making contact with the VRMs and VRAM chips and flashing it with a...

I'm running a 5600x on the B550i with the Black Ridge and Noctua A12x15. It runs low 60s at stock but it's easy to hit 90 with PBO2. I limit the PPT to control the temps, which would probably be a good idea with the 5800x. I thought I was stable with negative curves in benchmarks but then I...

I'm using this board and it does have some quirks. I've also had it not shut down with the power button, while tuning RAM. I also had no luck clearing the BIOS with the jumper. Instead I have to disconnect the little white CMOS battery connector, wait several seconds, and then reconnect it...

And after beta BIOS update with AGESA 1.2.0.0 I was able to boot into Windows at 4000MHz/2000 IF at 1.45v! Don't know if I'll bother tightening and testing though, I'm happy with a stable 3600C16 for now at a lower voltage. Getting 61.4ns latency.

Just to update this, with 2 sticks I'm apparently stable at 3600 16-22-18-36, Trc 64, Trfc 580 at 1.37v

Messing around with one stick of the D9WFL while waiting for more to arrive. I got it to 3400 14-20-16-36, tCWL 16, for a latency of 63.6ns. I haven't touched other timings yet. I can go higher speed but only with much looser timings. I'd be happy with this if the new sticks can't do better.

I got them on Ebay. Seller has no more so I just ordered from shopblt, we'll see what happens

Glad to see your results, I'm going for a very similar build. Same CPU, cooler, fan, and the Micron 3G2E1 sticks, on a B550i Aorus. I just got the system up and running and tried to do some quick tuning. One stick appears to be dead, so I'm only trying with one at the moment. I can get it to...

Yeah I may have to try something like that. I'm not sure why single slot cards are less than half the width of the double slot in this chassis. Unfortunately even if the widths matched there would still be slop at the bottom, since the mechanism has no way to stop the outside edges of the cards...

Sorry for resurrecting an old thread, I'm trying to put single slot cards in a Ghost right now and having this problem. The slop on the sides is making it difficult to secure them. Both the top and bottom of the cards slide sideways. The top and bottom screws are not sufficient for holding them...