Recent content by Ecki

Hello Thomas, i am sorry to inform you that this PC does not exist anymore in this form. I still have the cables for it though. I have not written down any lenghts but i pinned out one of each cable since i made all the pin cables the same lenght per each connector. The given leghts are with the...

Good and bad news for this.. Thanks to me beeing stupid, my 24PIN ATX connector fried my board -.- I kept searching for another one, but couldn't find the exact board i had in a new condition. So i bought something which was availible. An Asrock Z270i Fatality and an EK Velocity CPU Block as my...

Small Update on cables. Finished the 24 PIN yesterday late at night and had to rearrange every other cable previously done. Some zip ties for now until cables hold their new positions.

Might be it ^^ Here are some pictures

Thanks :) Did it yesterday like that, but i am not yet satisfied with it :/ Guess i have to do it again to make it look a bit better at least. I also tried to sleeve the kind of bulky USB 3.0 Frontpanel Connector. But i am not sure how to secure the sleeve to the connector. Zipties for now...

It's been a while since my last post. After messing up countless times on my last bend, i ordered ACF fittings and ZMT tube for now an got it hooked up. Days of searching leaks later it is now air tight and should work just fine once it gets filled up. First few cables are done too as you can...

Do you mean 31,0cm x 14,5 cm x 4,7cm? (lenght x height x thickness) if thats the case it will either not be possible, in need of a mod, extremely tight or i have to think about something else as a case. Card is 24,8cm x 12,3 cm x 5,5cm and has a 2 Slot bracket. But thanks to @Crossfire Machines...

Would it be possible to fit a 2,5 Slot Card in there by any chance? Like a Gainward GTX 1060 Phoenix GS? I could provide measurement for that if you need it.

Pump mount done First tubes are in. Currently waiting on more tubes to arrive, as I ran out of tubes trying to route the one from the pump to the cpu block and from the cpu block up Next up: finish last tube put in drain port valve shorten cables sleeve all the cables pressure test...

Hello SFF Forum my name is Ecki, I am from Germany and I would like to share my build with you all for feedback and tips on improving the result. There is lots of things I learned with this build, and there will be lots more in the future. Not everything will be perfect out of the box and if...