Recent content by dj52wtf

This was printed in PLA+ from Esun. It was printed with about 50% infill and isn't haveing any issues under heavy load for extended periods of time. I also took care to eliminate material wherever there was likely to be any heat sinking into the materials. Specifically directly under the CPU.

Below is a section view of the CPU cooler arrangement. The cover plate of the fan (black) is a very tight fit to the fan (tan). This is mostly because for adequate thermal performance it is wise to isolate completely the intake from the exhaust. You do not want the fan recirculating warm air...

Here from my 3D printed case thread. Nice work!!

My plan is to refine this design to fit a wider range of hardware then make the plans available, likely for a small fee, to anyone who would like them. As with everything there is some room for improvement and I personally am not 100% happy with it quite yet.

Current dimensions are 5.4in (138mm) Wide X 7.87in (200mm) tall X 7.87in (200mm) Deep

This was built using hardware that was a few years old mainly as a proof of concept. This was designed to replace another HTPC I had in the entertainment center. The processor is an i5 4440. The video card is a GTX 750ti. There is an SSD and a 2.5 mechanical 2 TB for storage. 8 Gigs of Ripjaw...

Fully 3D printed, small form factor, computer case. This was built using hardware that was a few years old mainly as a proof of concept. This was designed to replace another HTPC I had in the entertainment center. The processor is an i5 4440. The video card is a GTX 750ti. There is an SSD and...