Recent content by Divi

ooops, double post.. Feel free to leave any comments!

Small update after that first video from Jeff: AND NOW ITS DONE!!!

Reuploaded all the photos in the thread to another place, since it looks like local hosting at this forum is not long term. (waiting admin approval) I also sent one case to USA: There are couple little assembly errors on the video but they are already corrected for the final build. 👌

Allright, heres the files if anyone is interested. If any questions pop up, feel free to post here or email me through etsy. Plan is not to get rich with this, its just a small contribution for the creator and also etsy is a nice platform to share this. If you feel like its not right time for...

Allllright, my final build is done. Changes in this revision are listed in previous posts. Main changes happened behind the motherboard, a little bit more room for cable routing and M.2 drive. Here's how internals look with custom PSU cables All done, rear side: Right side, with brushed...

Quadro came in, and it seems to do exactly what I want. One minus, it can only control PWM fans, not DC, so my pump needs to be still controlled by motherboard.

A new toy. Temporary installation For a test, I ran cinebench and heaven and tested push/pull configurations for fans. - CPU/GPU act the same, temp is just depending what the tests are doing when taking the screenshot - M.2 is behind mobo so its also the same, just heats up slowly by time -...

Revision 2 has been assembled with water loop. Third revision has been finished in CAD and is waiting to get cut. Hardware: - AMD Ryzen 7 1700 - MSI B450I Gaming Plus AC - 16Gb Kingston HyperX 3200MHz CL16 - NVidia RTX 2080Ti 11Gb - WD Black SN750 1Tb M.2 NVME - Corsair SF750 Cooling: -...

And this is how it looks now, First image shows the orientation I'm planning to use it on my desk. These cover sheets are ment to be used only with watercooled GPU, but they would work fine with a blower card too.

Thanks for the comment! I have other diy stuff on desk with raw lasercut steel finish so I think I'll keep mine like this. Rust themed build would definitely be cool tho!

Ok, rev.2! PSU was moved to the side to make room for accessories and cables behind GPU. I made slots for nylocs in the bottom plate to avoid drilling and tapping. This also gives some wiggle room when putting the thing together. GPU screws fit now. Made a route for cables to get behind...

Hello, I bought Aquacomputer 2-pin water temperature sensor, and found out my mobo doesnt have sensor input. Building my own temperature controller with arduino is possible, but is there any small commercial solutions for this? Corsair Commander Pro at 70e is too much for just one sensor. Thanks!

Reserved for second prototype

First idea: I wanted a small open air case that would showcase GPU in a nice way. I also hate riser cables, so that was one major reason why I couldn't find anything suitable on the market. After looking for options, I decided to make on myself. Sizing: Size of the case is about 21x14x33cm...