Recent content by cpt.bubbles

  1. cpt.bubbles

    Production FormD T1 Classic (READ FIRST POST)

    Thanks for your goodwill but I think parcel would cost more than the cable itself if you sent one to me. :) I'll give 35cm a shot. Better to be bit too long than too short for how I want to route them.
  2. cpt.bubbles

    Production FormD T1 Classic (READ FIRST POST)

    Thanks, do you know what length the cables should be for the flipped orientation? I'll probably try them out first then worry about cable gauges. I'm not close to using up to 750 watts with my setup anyways.
  3. cpt.bubbles

    Production FormD T1 Classic (READ FIRST POST)

    Has anyone used PSU extension cords shaped like this in their T1? I'm looking into getting one because currently the stock cord is too long for the flipped PSU orientation. It's pushing on the GPU which I don't prefer. Wondering what length I should go with for a replacement cord.
  4. cpt.bubbles

    Production FormD T1 Classic (READ FIRST POST)

    Yes it will. You can check out the AIO compatibility chart too, and deduce if tech specs of a particular AIO will fit in the T1 if you are unsure.
  5. cpt.bubbles

    Production FormD T1 Classic (READ FIRST POST)

    I have a question: I am currently debating between the following two settings for my H100i in the T1. I've seen people use either orientation with their 240mm rads, but I'm not really sure which orientation I should go with. Which would net me a cooler, or quieter CPU (or GPU if it affects...
  6. cpt.bubbles

    Production FormD T1 Classic (READ FIRST POST)

    Can anyone tell me if the issue on this Reddit thread has been addressed? I'm expecting my case soon and I want to know if I should be trying to clip part of the bolt or just use three standoffs for the mobo.
  7. cpt.bubbles

    Production FormD T1 Classic (READ FIRST POST)

    Source (Reddit)
  8. cpt.bubbles

    Production FormD T1 Classic (READ FIRST POST)

    Anyone else had their T1 stuck in Zhengzhou? Mine was last reported there and has gone radio silence for a full week. Found out upon Googling that packages can get stuck there for weeks to even months. ?
  9. cpt.bubbles

    Production SENTRY 2.0: Evolution of console-sized gaming PC case

    This is interesting. I too am using PCIE 3 setting on the bios in prep for a 3000 series graphics card, but on an MSI B550I motherboard. Just tested SEQ1M Q8T1 on CDM for my Sabrent Rocket 4.0 1TB and it seems to show 5000Mb/s sequential read just fine.
  10. cpt.bubbles

    Advice FormD T1 + Other Unobtainable Things - Help Me Plan ?

    Is there a reason you split your storages into two 500GB m.2? I think going with a terabyte of one m.2 stick will be much better for your upgrade options when you eventually need more than a terabyte.
See more