Recent content by Chromavoid

EVGA 2080 FTW3 wont fit an NCase v6.1? Ive read conflicting reports... its not on the list, but some people have said the i/o is what gets in the way...however, I cannot confirm they are talking about the same card as the posts generally are a couple years old, different case revision...just...

Hi All, Does anyone have any insight or experience with cable management in a Cerberus? Im mostly referring to the area to the right of the motherboard. I have two SDD's in there, so along with their added clutter its also one of the only area's for the on/off switch wires and other fan...

ah, sorry missed this. Its a tight fit. If anything, the heat sink of the C14s would be resting against the fan. I'm not sure I want to disassemble anything just to see at this point. I'll keep looking to see if any other experience is out there

Quick question. I have a Cerberus case, non-X with the Asrock Z390 M-ITX board and a C14s cooler. Does anyone know if I can fit a 12x15 fan in the upper fan mount provided with the handle kit? Eyeballing it, it looks tight, but I have read both yes it will fit and no it wont. Any first hand...

Ahh, I forgot you have a Cerberus X, so likely a different motherboard and more room than I do. I have an Asrock m-itx in a Cerberus and have not much room above the C14S

Do you have a 12x15 mounted above the C14s? How much room do you have there if yes?

I ordered some PSlate Customs cables and installed the other day. I also bought a black housing, Purple colored LED Vandal switch because, well...because. Need to figure out how to wire it properly.

Thankfully I have not had any serious thermals to create any issues. My EVGA 2080 doesnt run very warm. I am aware of the panels wanting to slightly bend. Its annoying honestly and one of my only gripes about the case. I appreciate the firm connection all the panels have but man, its hard to...

well, this was surprisingly easier and cheaper than I anticipated. There is a local store called TAPS Plastics, they sell all sorts of plastics, vinyl etc.. They were able to mill out a piece for the window for $27 and I got a template in the process... I have the incorrect tape holding...

awesome, thank you so much. Looks like I can just find the right size plexi-glass and tape it on, or I can see if I can get a glass shop to bevel out a perfect fit so the window fits into the cut out on the panel perfectly... Thanks again

is the plexi flush with the outer plane of the panel? Or is there a gap? If it is flush, there would have to be some sort of bevel cut onto the plexi so it sits flush , right?

is the plexi cut to it sits flush with the outer plane of the panel? Or is it simply a rectangle of plexi taped inside with a noticeable ridge or gap between the case and the plexi? If that makes sense...

I dont know. I'm thinking it would be nice to have a custom cut panel of plexi so it fits right into the cut out, but I'm not sure how to execute this... I dont even know how the currently available full plexi panel is fitted and secured. I dont think Command velcro would allow a panel so sit...

Im not sure I follow. They have the side panel (half vented half glass) but without the glass. So I ordered one and will try to custom fit a piece of plexi-glass. Not sure how I will do that but I'll give it a shot!

Thanks for the suggestion. Its no longer available but they said they have a few remaining without glass in the warehouse. I ordered one, now I need to find someone who can likely custom cut some plexiglass!