Recent content by Baka

No worries! I have a decent idea on performance with the duals on mine but I may have to redo the setup since the coolant hits about 39c under load and I too, am a little worried once the summer heat comes. But it's nice to see the other setups and performances and gives ideas for the 2.0 lol...

It looks like you just have the 25mm fans. Do they do a decent job of pushing air through that 60? Or did you have to adjust the fan curve higher compared to your old dual 30mm setup?

i think you win the Clean AF award. i didn't even know you could route the PSU cable back up and around like that.

I know you've been looking for the ST20s which seem out of stock until 4/23 but thoughts on these? I heard they're not as efficient with the cylinder vs. flat tubing but pair them up with some 28mm fans to push more air through and they might be worthwhile.

No way! They're sold out? Feel like there's a shortage of everything these days.

Could you show us the improvement ideas that you have so far? I forgot to give my 2 cents but didn't want to repeat. Thanks!

Heyo! Just an update as I was able to get some stress testing done. Numbers pretty much match up to HaulinHP's numbers and super impressed with the cooling in this case. Even with the DC-LT's, I managed to get these temps with Time Spy and coolant temp never got above 39C. Day to day use sits at...

Oy she lives finally! Big ups to Protolyth, Taylor and crew for your 1st run success! The wait was long but damn, well worth it. Super fun to build in and hats off to you guys. Went for a minimalist look without using a res and took a gamble with a dual dc-lt pump setup because of their size...

I didn't see them post on here yet so just cross posting some new builds on Reddit from the weekend. HaulinHP updated evo8pudge

You're going to need custom cables to fit 2 slims and 2 regular size fans. I eyeballed and used Dan A4-H20 lengths which are a few mm longer than i need them to be but i think i can zip tie them down so they don't hit the blades. But here's what my WIP looks like so far.

Oh man. Been waiting for this week for like weeks. Stoked!

Not sure if this person is on here but just cross-posting HaulinHP's build from Reddit. 120 FTL with a trad layout. Quick Protolyth Slate Case Build : sffpc (reddit.com)

I think you should be okay with that setup if you use micro fittings. We have 327mm to work with and I've seen that setup in a Dan A4-H20 which is a mm shorter. 220mm for the block + 80mm for the FLT + 21mm for the fitting. But..I may be completely wrong as I also do not have a case yet either 😅

Here you go! It’s an Alphacool 120/140 mounting bracket.