Recent content by b4r

could you clarify the order of the wires on the corsair fan? You have the order as Yellow - Blue - Black - Green with the corsair header facing up. In the photo both headers are facing eachother meaning that they are mirrored. Wouldnt you want them to be facing teh same direction? Meaning the...

I have also done this mod. If you remove the top rails on the frame of the case you can fit the 120mm AIO bracket then reattach the top railds. I didnt need to remove anything on teh motherboard. I didnt screw in the bracket there is plenty of friction to hold it in place.

You absolutly need the stand offs ( reduce risk of a electrical short) I am using the aseteck 645 92mm AIO so i can use a standard PSU. The noise isnt bad the GPU is definitly louder than the 120 or 92 noctua fans. Im using the v3 so its rough to fit a fan under the motherboard.

Just rebuilt my dan a4. Anyone trying an aio with a 120mm fan over the motherboard? It is working well at this point though it was such a pain to do.

My daily driver is in a Dan A4 V3. CPU : Ryzen 7 3800x air cooled Gpu : RTX 2080 EVGA (blower card) I do a lot of CAD work so I went for a more powerful CPU. The 3800x isn't a good value but I got a deal so I have one. The 3600 and the 3700x have the same TDP at 65w and have the same...

Probably a long shot to be selected for test shipping. I haven't posted but I've been lurking for a while. I Have a DAN A4 and want the T1 to experiment with different cooling options. I have also been working with more niche configurations (stx MOBO eGPU) and hand fabricating my own enclosures...

I have had some good luck with cables from ADT. They have a section specifically for m.2 to pcie with the proper transfer speeds. The cables aren't too expensive and have a wide range of sizes but shipping to the US was $30.

Been doing a little research to do the sync I would use the power on and ground on the psu much like the papercliptrick for testing but then run a cable from the on to a 5v on my motherboard and the psu ground to the ground on the same header on the motherboard. I am using the Asrock Ryzen stx...

And thanks so much for getting back to me you forum posts have been very informative and help me a lot on my case building adventure.

Or did you mean 5v and sense on the plex yo the 5v and ground on the fan header

excellent if I can get one once they get to NA that would be great. I am a bit new to wiring. I have only done some custom cables for one of my PSUs. Do you mean I would connect a 5v and a ground on my HDPlex to a fan header cable?

Will the 360 be available by again? I have started a eGPU stx board project and am very interested in the form factor of this unit. It would be much easier than using m HDPlex 400. Also I would like to know more about the fan header sync cable if the 360 won’t be produced any more.