Recent content by alitech

Any ideas on where I can buy a new msrp 3080 in the US? I just need to learn some tricks on how to source one. I can see places please vest buy have them listed for $699 but sold out. Are you guys putting bots on certain pages? Is there a website where I can keep an eye on stock across the US?

10GB deliciousness unlocked!

Scratch that last post. I did it. I made the SFP+ card fit in between the bottom fan and the GPU waterblock. The ADT Riser is hanging in mid air but its not going anywhere, it is clamped down securely. I filed the heatsink of the nic and made it fit in between the small gap. This is only...

Yes, I assumed I would have enough space as I got a really slim radiator from aliexpress. 17mm thick and the fan is 15mm so it blocked the 2nd slot. I was also thinking of maybe just removing one of the fans at the bottom and just use a single fan, however the ADT riser was too short. Rather...

I thought I would be able to put the nic on the top of the case and get an M.2 riser to come right to the front Its a no go, I cannot fit the rad onto the lower screws on the case as there are too many things underneath. I may come back to this if i can find some tiny fittings for the 16mm...

My build is coming along ok however I have run into 2 issues. My disconnects leak and I am not able to fit the 10GB SFP+ card I was planning.. Here are some pics

Yup, standard config. GPU on the PCI slot and network card in the 2nd slot with the m.2 riser. I got the correct riser from aliexpress and checked it thoroughly. Will need to bend a stretch the cable slightly but should be good. The third slot will be covered up by rad and fans so no space...

Haven't worked that through yet as I am still waiting on the case but yes, I could do new stand-offs or just some extra strong sticky tape for the ADT riser. The Nic will be attached to the case with the bracket anyway, I don't know if just leaving it hanging inside will cause too much harm...

Thanks for the tip. Which software on windows did you use for the fan curve? Can you share a picture of how you have set up the fan curves for the 2 sets of fans? Also, why do you like that TechN cpu block over others?

awesome video

alitechno from reddit. Well done on your build. Awesome. What was the motivation to go small over temp control?

What sort of splitter would you use for this?

The specs Here is the spec. Any advice for the build most welcome New System: Ncase M1 - Ryzen 3950x - G.Skill Trident Z 64GB 4000Mhz - Trident 2TB PCIE-4 - *Corsair SF750 - Asus x570 i-gaming - Asus 1080ti Turbo 11GB - ADT M.2 riser for 10GB SFP+ Nic - Mellanox 10GB SFP+ nic Custom Loop: -...

Guys, I too am on the journey and almost have everything. Getting my Ncase tomorrow yeehaw! Here is the spec. Any advice for the build most welcome New System: Ncase M1 - Ryzen 3950x - G.Skill Trident Z 64GB 4000Mhz - Trident 2TB PCIE-4 - *Corsair SF750 - Asus x570 i-gaming - Asus 1080ti Turbo...